MEGGER TEST REPORT EN-MPS-725e FEMC / RPSC Paget 1 of 1 Revision 1 11/16//06 Approved by Wayne L. Cornell PROJECT NUMBER DATE (M/D/YYYY)
Date added: October 27, 2011 - Views: 1335
Only test a cable if the temperature of the conductor is above the dew point – otherwise, moisture will form on the surface of the insulation, and could be absorbed by the cable causing the test to fail; 3. ... Recommended Field Megger Testing
Date added: April 7, 2012 - Views: 245
www.iaei.org November . December 2010 IAEI NEWS 67 testing 600 v cable T here are a variety of technologies and methods used to test the insulation of wire and cable, in-
Date added: March 15, 2012 - Views: 12
Electrical Start-Up Procedure Document Number EN-MPS-725 Revision 0 ... Building Wire and Cable ... as appropriate. Utilize report form, Megger Test Report (EN-MPS-725e). Continuity Testing The continuity testing shall be in accordance with the Specifications.
Date added: November 6, 2011 - Views: 92
record the electrical test as specified for the Chilled Water and Instrument Air System ... Include the following in test report on each cable: a. Complete cable identification and description of isolation means. ... each test report: a. Megger readings, including converted values.
Date added: August 4, 2013 - Views: 12
The Owner shall be provided with a written test report, signed and dated, for all tests. ... The high potential test shall be performed at 45kVon new cable installations and at ... Capacitors shall be inspected for proper fuses before testing. A 1,000 volt megger test shall DC
Date added: December 20, 2011 - Views: 234
Insulation resistance testing Introduction Insulation resistance testers can be used to determine the integrity of windings or cables in motors, transformers, switch-
Date added: January 28, 2012 - Views: 151
Connect the positive lead of the megger to the cable bus wires and the negative lead to the metallic braid. 5 4 6 8 7 1 3 2. 2 ... Inspection Report Form for Electric Heat Tracing (Typical) Lmocation S) ... (megger) test should be performed using a 2500 Vdc megohmmeter for polymer-insulated ...
Date added: June 18, 2012 - Views: 4
Refer to the “FLX Cable Testing Report” for required recording of test data and circuit information. Upon Receiving Cable . . . 1. ... repeat the megger test with at least a 500 Vdc megohmmeter (megger) between the heating cable bus wires and the heating cable metallic
Date added: July 19, 2012 - Views: 2
The Owner shall be provided with a written test report, signed and dated, for all tests. Scope of Work . Acceptance tests shall be performed in accordance with applicable codes, standards and ... This test may be combined with the power cable megger test by testing the
Date added: May 3, 2012 - Views: 27
Structured Cable Certification Tests 2 NEXT, attenuation, and return loss are keys to ensuring that the cabling is capable of supporting high-speed
Date added: December 30, 2011 - Views: 23
Megger has had Primary Current Injection with: – DDA Series –CB Series ... such as test report generation, database management, trending etc. Programmable output ... Eliminates the users need for a communication cable. 7
Date added: April 19, 2013 - Views: 5
Understanding Insulation Resistance Testing (pdf) 02/06 Rev. 02 Technical Assistance (800) 343-1391 1 of 6 Understanding Insulation ... The first applies to new equipment or cable and can use AC or DC test voltages. When AC voltage is used, the rule of thumb is 2 x nameplate voltage + 1000.
Date added: September 29, 2012 - Views: 44
full transformer test report. Quick test mode provides the fastest testing of a transformer. Three excitation test voltages: 80 V, ... Use the Megger supplied Safety Ground Cable 15 ft (4.6 m) to connect the TTR300 Wing Nut Ground Terminal directly to Local
Date added: June 5, 2012 - Views: 9
UNDERGROUND SECONDARY CABLE TERMINATION & TESTING. See Hydro Ottawa’s Web site for the ... Hydro Ottawa shall provide a report of the megger test results. 2.7 Please Note: The meggering of the secondary cables is vital to ensure personnel
Date added: November 5, 2013 - Views: 3
Please contact Megger as soon as possible. TTR330 Transformer Turn Ratio test set . AVTMTTR330 Rev 3 March 2010 iv M . ... transformer test report ... connect the Ethernet cable between the TTR330 and the PC at this time. 5. Connect the Load-Tap-Changer cable ...
Date added: July 14, 2013 - Views: 2
Megger Cable Fault Locator Systems . Powered by Tripp Lite Inverters. SUMMARY. Customer. For over 100 years, Megger. has been the premier provider of electric test equipment and . measuring instruments for electrical power applications. With locations in the United
Date added: September 28, 2012 - Views: 7
DC High Potential (HI-POT) Testing of Medium-Voltage Power Cable Overview This procedure is intended to provide general guidelines for high potential ... solid grounds after the test on the cable for at least 4 times the dura-tion of the test. On exceptionally long
Date added: December 5, 2011 - Views: 35
Megger all cables and record the readings before and after the Hi-Pot test. 5. Measure temperature and humidity before the Hi-Pot Test and include these reading on the Test Report. ... Treat cable and tester as high voltage at all times. 3. Remember, D.C. static charges can be harmful.
Date added: April 2, 2012 - Views: 23
3.1.2 Minimum acceptable readings of each cable conductor to ground ... resistance test. 3.2 Test each cable conductor for continuity and complete ... in hard copy or approved transferrable media, of a report listing results of the requirements of 3.1 and 3.2, including circuit number, lead ...
Date added: November 29, 2012 - Views: 1
The Megger BM11 5 kV ... Test report sheets Rotating equipment ... Power cable ..... 210951-3 Bushing guard spring ..... 217003 “Lowdown on HV DC Testing” manual..... AVTM22P-1 Carrying case..... 218748 “A Stitch ...
Date added: December 10, 2012 - Views: 18
Ground connection cable, 10 ft [3 m] 4702 Test record card, universal 210954 Power cord, ... Test report sheet for rotating equipment 210951-1 ... Megger is a registered trademark. Title: MEGOHMMETERS_DS_en_V10
Date added: January 16, 2014 - Views: 1
Megger Cable Fault Location PFL40 series. 2 Megger’s new PFL40-1500/2000 Power Fault Locator. ... • 25mA constant test current ... recall, report generation assists with asset management.
Date added: August 27, 2014 - Views: 1
TEST RECORD SHEET Date: Tested by: Sheet No.: Client Name: Address: Installation type: Metering type: ... Cable No. Of Points Over current Protection Min. Insulation Resistance (MEG OHMS) Polarity L-E Fault Loop Imp (Ohms) RCD Trip Time
Date added: February 19, 2012 - Views: 52
Megger DETAILS OF THE CLIENT Certificate No: 33 PERIODIC INSPECTION REPORT FOR AN ELECTRICAL INSTALLATION (REQUIREMENTS FOR ELECTRICAL INSTALLATIONS - BS7671 [IEE WIRING REGULATIONS]) ... Referring to the Schedule(s) of Inspection and Test Results, ...
Date added: August 8, 2013 - Views: 1
The saturation test is performed at mains rated frequency ... uploaded to Megger’s PowerDBTM Lite for report generation and saturation curve plotting on a computer. ... Ethernet crossover cable (1 ea) 620094 Instruction book 750025 PowerDB Lite 544342
Date added: May 20, 2012 - Views: 9
summarized in a Certified Test Report (CTR), which can be used as a means to compare industry standard requirements ... the cable and reel while performing a megger test. On-reel testing of shielded cables involves a slightly different method of verifying the
Date added: October 25, 2013 - Views: 3
megger or hipot or in service – the insulation molecules polarize. Because it takes time for the insula- ... the PI test. Title: Use Polarization Index Test To Determine Condition/Health Of Motor Insulation Author: Chuck Yung Subject: Sept. 2000
Date added: December 23, 2011 - Views: 75
Sl. No. PARTICULARS REMARKS REFERENCE DOCUMENTS AND INSTRUMENTS USED FOR CHECKING 4 LT-SWITCH GEARS MFRs test report must be with material.
Date added: March 18, 2014 - Views: 1
Electrical Test Instruments The word ‘Megger’ is a registered trademark. ... test report book 1001-227 Fail label roll of 1000 1000-971 Pass label roll of ... Cable Certifiers Prices. Business in a box Why diversify your
Date added: August 4, 2013 - Views: 1
Test Parameters – Display Header ... Please contact Megger as soon as possible. MTDR1 Time Domain Reflectometer . M AVTMMTDR1-ENG Rev A Dec 2006 2 M. AVTMMTDR1-ENG Rev A Dec 2006 3 MTDR Analyzer Specifications Operating modes: ARC Reflection, SURGE, voltage Decay
Date added: August 29, 2014 - Views: 1
Megger your Test & Measurement Solution for Power Systems Electrical Installations ... Report Generator Tools Records all PQ parameters. 29 HV Dielectric Test Sets Testing to 70kV, 120kV or ... Cable Test Vans
Date added: June 8, 2014 - Views: 1
3-Phase Transformer Turns Ratio Test Set ... processing, data trending, report generation) in an XML file with all historical data. ... printer interface cable, and shelf for mounting printer Calibration Standard (for TTR verification) 550555
Date added: November 28, 2011 - Views: 22
transformer test report. ... cable for testing transformers with Load-Tap-Changers. 5. H ... Use the Megger supplied Safety Ground Cable 15 ft (4.6 m) to connect the TTR330 Wing Nut Ground Terminal directly to Local Station Earth ground.
Date added: August 19, 2013 - Views: 4
2 BT pecia eport cable’ ne orld SPNSORED Y Special report Test, Measurement and Monitoring in Cable’s New World The cable industry has been an exciting place
Date added: August 29, 2014 - Views: 1
Megger not only manufactures and markets high quality test and measuring instruments. Megger also employees a staff of people who are experts in their
Date added: May 12, 2013 - Views: 11
Cable Pulling Card Megger Test Report –Cables Megger Test Report – Circuits ... Induction Motor Checklist / Test Record ... Cable Megger Test Inspection Request Final Take- Over Certificate
Date added: October 1, 2013 - Views: 8
Megger Limited PWS / April 08 MIT 5kV 10kV Refresh ... These products are used to test insulation in the following applications: ... • Cable Manufacturers • Electrical Contractors o Contracted to Power Utilities
Date added: January 28, 2014 - Views: 1
Cable insulation resistance ..... 8 High-Voltage DC Tests - Rotating Machines 22. Application - rotating machines ... c. Record all data on the "Oil and Insulation Test Report," form PO&M 109. Plot the di-electric absorption and temperature correction curves. Calculate polarization index.
Date added: December 24, 2011 - Views: 25
How Is The Test Performed? The cable to be tested must be de-energized and each end isolated. Using a VLF AC Hipot, the test voltage is applied to the cable while the tan delta controller takes measurements.
Date added: December 8, 2011 - Views: 31
Ground Testing FAQs Can I use an insulation tester to do the same test? No. This is a common error. Field operators are often issued a MEGGER ® instrument from stores,
Date added: January 29, 2012 - Views: 38
and report the results back to the test form. The DELTA4000 ... Region dependent; please contact your nearest Megger Sales Representative for details. Available in 1-yr, 3-yr, and 5-yr ... Input power cable 25A EU 17032-23
Date added: September 8, 2013 - Views: 2
MDP Series Megger Distribution Profilers Choice of three models that record currents up to 1000 amps, with an additional 200 amp over-range Waveform capture and harmonic
Date added: May 23, 2012 - Views: 4
600V cable insulation test. C. Field Test and Operational Check: ... The test report shall include the following: 1. Summary of project. ... FIELD TEST AND OPERATION CHECK 16080 A. Megger and record insulation resistances of the main service, panel feeders, and all
Date added: June 23, 2012 - Views: 1
www.megger.com . MR4 METER ADAPTER RECORDER ... RS-232 Interface Cable ... 69 view test data from the recorder, 67 report generation, 85 voltage histogram report, 101 resetting an mr to initial conditions, 38 ringless meter socket installation, 21
Date added: October 8, 2012 - Views: 3
can also damage the device and cable under test. Always cover the device’s fiber optic connectors with the dust caps when not in use to reduce the possibility of contamination. ... (PN 6280-354), contact your local authorized Megger dealer.
Date added: June 25, 2013 - Views: 1
cable Test Report for the prescribed minimum values. If prescribed minimum values are required for higher voltage Paper Lead (PLY) cables, ... USING 500V megger measure insulation resistance between internal wiring and standard ...
Date added: May 11, 2012 - Views: 14
support to assure full utilization of the Megger DELTA-2000. ... The package also provides test documentation and trending, report generation and a number of other ... RS-232 cable 34675-1 High voltage lead, 25 ft (7.6 m) 30012-8
Date added: May 9, 2013 - Views: 4